Stamping - Moldable Faom Stamp Instructions

1. Heat foam block with a heat gun in a constant motion all over area (300’ to 400’ F) for about 30 seconds.
2. Press the foam block quickly against any textured surface. Hold in down firmly for about 15-20 seconds.
3. You can ink your foam stamp now with any water based inks or markers.
4. Press your inked foam stamp onto the item you wish to stamp. Apply even pressure on the stamp.
5. You can wash your stamp with water and a little bit of soap. The stamp holds its impression until your reheat it!

Home | Gift Certificates | Order From Catalog | Request a Catalog | Contact Us
Join Our Mailing List | Customer Service | Track an Order | My Orders | Email This Page
If you'd rather speak with a human, please call toll-free from anywhere in the U.S. or Canada 8am to 5pm PST
Phone: 800-542-5227
Copyright © 2009 Dharma Trading Co. All Rights Reserved.