1. Carefully remove the metal cap from the ornament. Squirt the Pinata Colors inside. Touch the tip of the
bottle to the glass while your squeezing so that the color runs down the inside of the ornament. Not too
much—you want the paint to drip down the sides without puddling up too much on the bottom. When you are happy
with how it looks, set it aside and let dry.
2. Paint the small leaves with Lumiere and let dry.
3. Wrap short pieces of craft wire around the stems of the leaves. If you are using dried leaves, the
stems may be brittle so use a bit of craft glue to secure them to the wire.
4. Wind the wire ends around a pencil or the end of your paintbrush to give them a bit of curl.
5. Put the leaves inside the ornament one at a time. Thread the non-leafy ends of the wires through the metal
cap and adjust the lengths so that the leaves hang at different levels and don’t touch the bottom of the ornament
too much. (This part may be kinda tricky, mostly if you are using real leaves. Handle them gently so as not to
crush them.) When you are happy with the way the leaves hang inside the ornament wind the wire ends together and
wrap them around the top of the hanger.
6. Finish off by tying a little accent ribbon at the top—or personalize it with an ExtravOrganza ribbon!
Are you a "fan"?
Twitter
MySpace
StumbleUpon
Google Reader
Google Bookmark
Y! Bookmark
