Professional Metal Tip Gutta Applicators

This is the best of the metal tips for applying guttas and resists. It comes with its own little plastic case with a wire 'hole cleaner.' The squeeze bottle comes with it. It is a little more difficult to put together than our other gutta applicators, but pros say it's worth it. You cut off the end of the spout 1/8 inch below the first joint and then insert the tip from the inside so the end pokes out. Use a ballpoint pen to gently push the tip in so the tip protrudes a little and stays there. Easy does it, if you push too hard, you'll split the plastic. The big advantage here is that the tip can't possible come off unexpectedly, and it gives you better control over the resist lines, also comes in a finer size than other applicator bottles, for the finest of fine lines! Useful for applying gutta, water based resists and medium to thick consistency paints or thickened dyes in a fine line.