My Palette
Drag Color Chips
Stamping - Moldable Foam Stamp Instructions
1. Heat foam block with a heat gun or hair dryer in a constant motion all over area (300F to 400F) for about 30 seconds.
2. Press the foam block quickly against any textured surface. Hold in down firmly for about 15-20 seconds.
3. Ink your foam stamp now with any water based inks or markers.
4. Stamp your inked foam stamp onto the item you wish to stamp. Apply even pressure on the stamp.
5. Reheat. You can wash your stamp with water and a little bit of soap. The stamp holds its impression until your heat it up again!

Customer Comments

If you'd rather speak with a human, please call toll-free from anywhere in the U.S. or Canada M-F 8am to 5pm PST
Phone: 800-542-5227

Drag and Drop chips to the Palette first.