Jacquard Airbrush (& Marbling) Colors

Jacquard developed these inks specifically for airbrush applications. They are available in Transparent, Opaque and Metallic colors, all of which are water based and intermixable. This is the first and only thin paint we have that comes in Opaque colors for dark fabric! The colors will work on almost anything, including fabric, leather, wood, plastic, and metal. For use on non-porous surfaces, some light sanding may be required, and bare metal may need a base coat of primer. Heat setting with a heat-gun or dry iron is recommended for permanency.

We also tried these inks for marbling purposes and found that they work great; the colors are vibrant and float well. Because they are thin, they can also be used for a non-toxic chemical free faux tie-dye. See our How To section - Tie-Dye with Fabric Paint.

All colors are non-toxic and conform to ASTM D-4236.

Surface Preparation: All surfaces must be clean. Leathers and fabrics must be washed to remove dirt, waxes, sizings and conditioners. Non-porous surfaces, like metal and plastic, may require light sanding. Bare metal may require a primer.

Application: Apply in light even coats. Avoid over-saturating the surface. Use approximately 40 psi and nib size should be no less that 0.5 mm. Paints are intermixable to get a full range of colors. Heat set paint with heat gun on hard surfaces. For fabric, heat set with a dry iron at appropriate setting for fabric for 30 seconds.

Varnish Instructions: (Optional) After airbrush paint has completely dried, spray varnish in a light even coat. Repeat, if desired, after first coat has thoroughly dried.

Tips for Airbrushing

• Before starting on your piece, check to make sure all of your equipment is working properly. Check for bent needle or tip and replace if necessary. Make sure that the compressor is functioning correctly and you have the air pressure adjusted to where you want it.
• Be sure you are using the correct size tip, especially with the Metallic Colors.
• Don't let colors sit too long in the airbrush without use, causing paint to dry in the airbrush.
• Place caps on bottles when not in use so they do not dry out.
• Dilute Colors with water to thin paints slightly.
• Be sure to clean your equipment thoroughly when you are finished.
• Transparent Colors are best on white and light colored surfaces.
• Opaque and Metallic Colors work on either light or dark surfaces.